Braun RA300 Mobility Aid User Manual


  Open as PDF
of 47
 
Page 14
Disconnect the power cable at the battery prior to servicing.
Keep hands, arms and all other body parts clear of moving parts.
Never modify (alter) a Braun Corporation ramp.
Replacement parts must be Braun authorized replacements.
Never install screws or fasteners (other than factory equipped).
Whenever replacing a hydraulic cylinder or seals, deploy ramp fully.
)DLOXUHWRIROORZWKHVHVDIHW\SUHFDXWLRQVPD\UHVXOWLQVHULRXVERGLO\LQMXU\DQGRUSURS-
erty damage.
Installation/Service Safety Precautions (Continued)
W
A
RNING
Read this manual,
before performing
installation, operation
or service procedures.
Failure to do so may
result in serious
bodily injury and/or
property damage.
Installation Requirements
Braun RA300 Ramps must be
installed and serviced by a Braun
authorized service representa-
tive who has attended and been
FHUWLÀHGE\7KH%UDXQ&RUSRUD-
tion Sales and Service School for
Braun Mobility Products.
SRFNHWµFRQÀJXUDWLRQQRWVXS-
plied).
Slope:7KHSRUWLRQRIWKHÁRRU
where the ramp mounts must
slope at an approximate 8° angle
(see Figure C).
Outboard Support Tube: An
outboard support tube must be
positioned under the outboard
edge of the opening (minimum
1-1/2” x 2” steel tube). See Fig-
ures C and D. The recommended
height of the support tube is 12”
above ground level. Kneeling
Vehicles: This dimension mea-
sured with suspension lowered.
ADA: Installations with the sup-
port tube positioned higher than
12” above ground level may not
comply with ADA ramp slope
requirements.
Some OEM chassis meet these
VSHFLÀFDWLRQV7KH5$UDPS
was designed to conform to these
VSHFLÀFDWLRQV
The ramp pan horizontal bor-
GHUOLSVHWVRQWKHÁRRUSRFNHW
SHULPHWHUIUDPHZRUNVXEÁRRU
HWF7KHÀQLVKHGÁRRULQJFDQEH
cut to conform to the border of the
SDQIRUDÁXVKWUDQVLWLRQVXUIDFH
IURPUDPSWRÁRRU
RAMP INSTALLATION
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
Chassis Requirements
The Braun RA300 Ramp is de-
VLJQHGIRUXVHLQORZÁRRUWUDQVLW
YHKLFOHV$´ÁRRUSRFNHWµPRXQW-
ing hole) built into the chassis/
ÁRRUV\VWHPDOORZVIRUVLPSOHLQ-
stallation (accepts “drop-in” unit).
The Floor Pocket Clear Open-
ing DimensionsDUHVSHFLÀHGRQ
pages 15 and 16. See Figures B,
C, D and E.
The ramp installer must provide
an appropriate framework in the
applicable location in the vehicle
(aligned center with passenger
door opening). Ramp assembly
mounting hardware and/or brack-
ets are directly dependant upon
WKHYHKLFOHFKDVVLVDQG´ÁRRU
Read and become familiar with
the operating instructions and the
installation instructions contained
in this manual before beginning
installation, operation or service
procedures.
W
A
RNING
 previous next