Filter
Top Products
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 31312
Cam
Switch
Screws
Inner
Cam
C
A B
Outer
Cam
Switch
Switch
Arm
Vertical
Arm
Deploy Limit Switch
Screw
Cam
Stepwell Application
Dropped Floor Application
Deploy Limit Switch
&IGURE1
&IGU
RE2
&IGURE3
Floor Level Cam Adjustment:
The floor level cam(s) are located on the lower drive
arm shaft, on the rear side of the frame tube (under
the cover).
Adjust per application.
• Stepwell Application (Figure Q)
1. Position platform at floor level.
2. Loosen the two cam screws.
3.
Adjust the cam for proper switch activation.
4.
Tighten the two cam screws.
• Dropped Floor
Application (Figure R)
• Up-Stop Adjustment (inner cam and switch):
1. Position platform at original
floor height
(full up position).
2. Loosen screws A, B and C.
3.
Adjust the inner cam for proper switch
activation.
4.
Tighten screw B.
• Floor Level Adjustment (outer cam and
switch):
Activated when the platform switches from the
up/down positions to the stow/deploy positions.
1. Position platform at lowered
floor level.
2. Loosen screws A and C.
3. Adjust the outer cam until the floor level
switch activates.
4.
Tighten screws
A and C.
Deploy Limit Switch
Adjustment (Figure S)
This switch adjusts the angle of the platform when
positioned at
floor level. The platform should be
level with the van floor. The switch is located on the
vertical arm where the switch arm pivots.
1. Position platform at floor level.
2. Loosen the screw that secures the cam to the
vertical arm.
3. Level platform using a level (or as needed).
4.
Adjust cam so the deploy limit switch activates.
5.
Tighten screw.
6.
Verify position and check level.
5
,IMIT3WITCH!DJUSTMENT
The outer barrier will not raise if occupied by at
least 25 pounds.
An audible warning will activate if at least 25
pounds is on the threshold area when the plat
-
form is at least one inch below floor level.
Raising the platform more than 3” off of the
ground is prevented unless the outer barrier is
raised.
Verified:
Vehicle movement is prevented unless the
platform is fully stowed.
Lift operation shall be prevented unless the
vehicle is stopped and vehicle movement is
prevented.
The platform will not fold/stow when at least
50 pounds is on the platform.
6
&-633#ERTIlCATION#HECKLIST
-USTBE#OMPLETEDAND3IGNED
2%15)2%$"9&%$%2!,,!7
2%15)2%$"9&%$%2!,,!7
The operations listed below must be
functionally veri
fied. This lift is not available
for use unless these operations have been
verified by the installe
rʼs signature below.
DOT — Private Use Lift
Threshold
Warning Sensor
Audible
Threshold
Warning
Inboard
Locator
Platform
Switch
Arm
Outer Barrier
Verified By:
Process, fold and insert completed document in
the lift-mounted operato
rʼs manual storage pouch.
Signature Required
Lift Model: Series No: Serial No: