Filter
Top Products
Introduction 10
adjust and check BARCOs medical displays.
A lot of adjustments can also be done on the monitor itself, by means
of an extensive on-screen menu system, accessible from the rear
panel controls.
Power saving system
The MGD 521 displays are equipped with a power saving system.
When left idle for a certain time, the computer, connected to the
display, will power down the display in several steps. The power
saving system can be switched on or off during the installation or
adjustment of the display.
This system requires a computer imaging board that supports power
saving management.
1.2 Versions and options
MGD 521 M MGD 521 MKII
P45 phosphors ................ x .................................. x
P104 phosphors .................................................... x
50 Ohm input .................. x .................................. x
75 Ohm input .................. x .................................. x
Notes:
- The P45 phosphors produce rather bluish images, whereas the
P104 phosphors produce more yellowish images.
- A video input terminated to 50 Ohm requires an imaging board
with an impedance of 50 Ohm. A video input terminated to 75 Ohm
requires an imaging board with an impedance of 75 Ohm.
- The type of CRT phosphors and the video input termination are
indicated on the label at the rear of the display.
Important:
It is absolutely necessary that the impedances of imaging board and
display are the same. If not, the image quality will be inferior.
The MediCal software and the X-Rite DTP92 sensor are not delivered
with the display.
MediCal can be ordered separately.