Filter
Top Products
15
9. ADDITIONAL INFORMATION
This section describes the additional functions and corrections to the instruction manual of
FS-i series (WM+PD4001332 and 1WMPD4001368) which are common to the FS-D.
9-1. F-Function list
The following function settings are added (“11-2. Function list” in WM+PD4001332).
Item
Function number
Description
f06- 5
Multi-connection with print key mode
(RS-422/485)
f06- 6 Auto-print mode + data & OK
Serial interface
Data output
mode
f06- 7 Auto-print mode +/- data & OK
The UFC format
is applicable to
f06-2 to 4.
f13- 0 Zero tracking OFF
f13- 1 Zero tracking ON, 0.5d/sec
f13- 2 Zero tracking ON, 1.0d/sec
Zero tracking
f13- 3 Zero tracking ON, 2.0d/sec
Setting C04-0,
f13-2 and 3
cannot be set.
f21- 0 Auto-tare function disabled.
Auto-tare
function
f21- 1 Auto-tare function enabled.
f22- 0 Immediately after OK and stable
f22- 1 0.5 sec. after OK and stable
f22- 2 1.0 sec. after OK and stable
f22- 3 1.5 sec. after OK and stable
f22- 4 2.0 sec. after OK and stable
f22- 5 2.5 sec. after OK and stable
f22- 6 3.0 sec. after OK and stable
f22- 7 4.0 sec. after OK and stable
f22- 8 5.0 sec. after OK and stable
Auto-tare timing
f22- 9 6.0 sec. after OK and stable
Timing to tare
automatically
after the comp.
OK and weight
stable.
To be used with
f21-1.
f23- 0 Function disabled
Auto-tare for the
initial weight
f23- 1 Tares the initial (container) weight.
Automatic
operation.
f24- 0 Normal comparison
Normal/Negative
comparison
f24- 1 Negative comparison for take-away
Factory setting
9-2. OP-03 RS-232C
The followings are the corrections and the additional information for the optional
interface (“2-2. OP-03 Specifications” and “2-3. Command Mode” in 1WMPD4001368).
Circuit diagram
4 Signal ground SG
5 Frame ground FG
6 Shield
4 Signal ground SG
5 Shield
6 Frame ground FG