236 Appendix A: Parameter Lists
02R96—Owner’s Manual
REV+FLANGE
One input, two output reverb and flanger effects in parallel.
REV->FLANGE
One input, two output reverb and flanger effects in series.
Parameter Range Description
INI. DLY
0.0–500.0 ms Initial delay before reverb begins
REV TIME
0.3–99.0 s Reverb time
HI. RATIO
0.1–1.0 High-frequency reverb time ratio
DIFF.
0.1–1.0 Spread
DENSITY
0–100% Reverb density
HPF
THRU, 21.2 Hz–8.00
kHz
High-pass filter cutoff frequency
LPF
50.0 Hz–16.0 kHz,
THRU
Low-pass filter cutoff frequency
REV/FLG
0–100%
Reverb and flange balance (0% = all reverb, 100% = all
flange)
FREQ.
0.05–40.00 Hz Modulation speed
DEPTH
0–100% Modulation depth
MOD. DLY
0.0–500.0 ms Modulation delay time
FB. GAIN
–99 to +99%
Feedback gain (plus values for normal-phase feedback,
minus values for reverse-phase feedback)
WAVE
Sine, Tri Modulation waveform
SYNC
OFF/ON Tempo parameter sync on/off
NOTE
1
1.
Used in conjunction with TEMPO to determine FREQ.
Parameter Range Description
INI. DLY
0.0–500.0 ms Initial delay before reverb begins
REV TIME
0.3–99.0 s Reverb time
HI. RATIO
0.1–1.0 High-frequency reverb time ratio
DIFF.
0.1–1.0 Spread
DENSITY
0–100% Reverb density
HPF
THRU, 21.2 Hz–8.00
kHz
High-pass filter cutoff frequency
LPF
50.0 Hz–16.0 kHz,
THRU
Low-pass filter cutoff frequency
REV BAL.
0–100%
Reverb and flanged reverb balance (0% = all flanged reverb,
100% = all reverb)
FREQ.
0.05–40.00 Hz Modulation speed
DEPTH
0–100% Modulation depth
MOD. DLY
0.0–500.0 ms Modulation delay time
FB. GAIN
–99 to +99%
Feedback gain (plus values for normal-phase feedback,
minus values for reverse-phase feedback)
WAVE
Sine, Tri Modulation waveform
SYNC
OFF/ON Tempo parameter sync on/off
NOTE
1
1.
Used in conjunction with TEMPO to determine FREQ.
