30 – 36x Network Smart Dome Camera
how to use osd menu
Edit Pattern
c By using Joystick, move to start position with
appropriate zoom. To start pattern recording,
press ENTER key.
d Use Pan/Tilt/Zoom to specify the Pattern Start
point and press Enter. If you run a pattern to
save, the route of the pattern will be recorded.
The total memory size and the rest memory size
is displayed in the form of bar. Maximum 1,000
communication commands can be stored in a
pattern.
e To save data and exit, press ENTER key.
❖
SCAN SETUP
SCAN NO. [1~8]
Selects Scan number to edit.
If a selected Scan number is not defi ned,
“UNDEFINED” will be displayed under selected Scan
number.
CLEAR SCAN [CANCEL/OK]
Deletes data in current Scan
EDIT SCAN Starts editing Scan.
Edit Scan
c Press ENTER key in “NO” list to start Scan
setup.
d Note that Max. 20 Functions are allowed in a
Scan. Move cursor up/down and press ENTER
key to set up.
•
•
•
❖
EDIT PATTERN 1
MOVE TO START POSITION
[ENTER : START]
0/0/x1/N
EDIT PATTERN 1
[ENTER : SAVE]
0/0/X1/N
SCAN SETUP
SCAN NO. 1
UNDEFINED
CLEAR SCAN CANCEL
<EDIT SCAN>
BACK
EXIT
EDIT SCAN 1
NO. ACTION NO. DWELL OPT
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
SAVE
CANCEL [ENTER : EDIT]
EDIT SCAN 1
NO. ACTION NO. DWELL OPT
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
SAVE [ENTER : EDIT ACT]
CANCEL [LEFT : EDIT END]
