66
Fluorescent Light Mode
Choose this mode to shoot subjects under fluorescent light where an appropriate white
balance is difficult to achieve.
Note
• Select this mode from the white balance mode settings menu. See
“Displaying the Settings Menu” (p.63).
q Press the or button to select the
mark.
The fluorescent light mode is now set.
w Press the shutter release button to shoot
the subject.
When you press the shutter release button
lightly (halfway), the LCD monitor switches to a
normal display. Press down the shutter release
button fully to shoot the subject.
When the shooting ends, the setup menu is
displayed again on the LCD monitor. To accept
the new adjustment level, press the ENTER
button; to cancel it, press the MENU button to
return to the record menu. Then, press the
menu button once again to exit the record
menu.
Important
Note
• The color tones of a subject will vary depending on the type of light source
(fluorescent light).
How To Cancel the Fluorescent Light Mode
Press the or button on the setup menu to switch to auto mode.
WHITE BALANCE
AUTO
CANCEL:MENU SEL.:ENTER
