Adjusting the Printer
50
4
Adjusting Tray Registration
You can adjust the registration of
each tray. The vertical adjustment is
used for all trays. Normally, you need
not update the registration. But when
the optional paper feed unit or the
duplex unit is installed, updating is
useful in some cases.
The following procedure describes
how to adjust tray 2. The same proce-
dure applies to other trays as well.
A Press the {Menu} key.
The [Menu] screen appears on the
display.
B Press the {U} or {T} key to dis-
play [Maintenance], and then press
the {# Enter} key .
The maintenance menu appears.
C Press the {U} or {T} key to dis-
play [Registration], and then press
the {# Enter} key .
The registration menu appears.
D Print the test sheet to preview the
settings. Confirm that [Prt. Test
Sheet] is displayed, and then press
the {# Enter} key.
A screen prompting you to select
the tray to be adjusted appears.
E Press the {U} or {T} key to select
the tray to adjust, and then press
the {# Enter} key.
The test sheet prints out. The dis-
play returns to the registration
menu. Press the {Escape} key.
F Confirm the position of the image
on the test sheet, and then adjust
the registration value.
G Press the {U} or {T} key to dis-
play [Adjustment], and then press
the {# Enter} key.
H Press the {U} or {T} key to set the
registration value (mm).
Menu:
Maintenance
AGN503S
Prt. Test Sheet:
Tray 2
Adjustment:
Horiz: Tray 2
Horiz: Tray 2:
(-4.0 +4.0) 0.0
ZKGX480E
KirP4GB_Mainte-F6_FM_forPaper.book Page 50 Thursday, May 12, 2005 11:48 AM
