Replacing the Maintenance Kit
41
2
B Lift the lock levers of the fusing
unit as shown in the illustration.
C Pull the fusing unit out.
D Pull out the pins on both sides of
the new fusing unit.
E Replace the new fusing unit into
the printer.
F Push the lock levers of the fusing
unit down until it clicks.
G Align the power cable with the
groove of the left slide of the du-
plex unit, and then insert the du-
plex unit into back of the printer
aligning the rails inside of the
printer until it is connected.
AGN006S
AGN007S
ZKGM010E
AGN008S
AGN009S
ZKGX240E
KirP4GB_Mainte-F6_FM_forPaper.book Page 41 Thursday, May 12, 2005 11:48 AM
