17
Nobeltec InSight Radar (IR2)
Operations Manual
Setting the Radar Presets (4kW Models and Above Only)
The auto gain and auto sea functions allow for hands free operation of the radar. As
with any other setting on the radar, these modes must be properly set up in order to
operate correctly. The following sections describe the presets that must be set for
proper operation.
There are several presets that affect the quality of the image. This section only
reviews those that affect the performance of the radar while using the “auto”
functions.
The dialog above is used for all preset controls (your actual values may vary from
those in the image). Pressing OK applies and saves the changes you have made.
Pressing Cancel eliminates any changes you have made, and restores the settings
prior to modification. Restore Defaults sets the values to factory defaults.
Follow the instructions below to adjust specific preset values on the radar.
Auto Tune Preset Controls
The Nobeltec radar is always in auto tune mode. In order to optimize the image, it
is necessary to set the auto tune preset to make sure you are receiving the best
quality image possible. Once set, you should not need to adjust the auto tune
preset unless the image quality deteriorates out of the control of the auto control.
Generally, you should adjust the auto tune preset once a year to make sure you
have the best image.
Follow these steps:
1) Select Adjust Radar Presets by right clicking on the radar image window or from
the Radar menu.
2) Adjust the auto tune control down until you see the image start to deteriorate.
Note the value of the setting.
3) Adjust the auto tune control up past the point where the image looks good until
the image starts to deteriorate.
4) Select the point between the two where the quality of the image is at its best.
Setting up IR2
