9
Nobeltec InSight Radar (IR2)
Operations Manual
Using the Radar Setup Wizard
This section assumes that you have correctly installed the IR2 and that it is
functioning properly.
The Insight Radar option to the Nobeltec software includes a Radar Setup Wizard
that simplifies the integration process. You must run the Radar Setup Wizard the
first time you install the software on a new computer on which you want to see the
InSight Radar.
The Wizard also sets up the communication ports for other NMEA devices such as
a GPS, heading sensor and more.
IMPORTANT NOTE FOR NETWORKS
When running the Radar Wizard, it is important that you turn off all
IR2 radars and copies of Nobeltec software connected to the network
except the IR2 radar that you want to connect with.
To launch the Radar Setup Wizard
1) Click on the Start button on your Windows task bar. Then Programs | Nobeltec
| Radar Wizard
If the Radar Setup Wizard is not in the Nobeltec program group, you have not
installed the Nobeltec software with the Insight Radar module. Check to make
sure that you installed the correct CD.
2) After the opening screen appears, click on the Next button.
3) Verify that you have accomplished all of the requirements as outlined and then
click on the Next button.
Setting up IR2
