8
Nobeltec InSight Radar (IR2)
Operations Manual
Installing Nobeltec Software
It is necessary to install this software even if you have Nobeltec software already
loaded on your system. In addition to installing the Nobeltec software on a new
computer, it can also upgrade existing Nobeltec software to recognize and operate
the InSight Radar 2.
To install the Nobeltec software, Insert the program CD into your CD-ROM drive.
The program will autorun an installation program.
Follow the on screen instructions to install or update the Nobeltec software.
If the CD does not autorun, follow the next set of instructions.
1) Select Start | Run from the taskbar and type E:\setup.exe (substitute the drive
letter of your CD-ROM drive for “E” if it is different).
2) Follow the on screen instructions to install or update the Nobeltec Software.
Once installed, you should see a splash screen similar to the one shown below.
Nobeltec Admiral’s Splash Screen showing the
InSight Radar components are installed.
Tip: Notice that in the lower right corner, under the banner:
“Including”, the InSight Radar components are installed. If you do
not see this, chances are good that you have installed the wrong
CD. Locate the correct CD and re-install.
Setting up IR2
