18 Optional Accessory Installation
MX7 User’s Guide E-EQ-MX7OGWW-C
Optional Accessory Installation
Attaching Handstrap
Note: Either the trigger handle is attached to the MX7 or the handstrap is attached, not both.
LXE recommends that, in the absence of a trigger handle, the handstrap be used at all
times. LXE pre-installs the handstrap on devices that are purchased without a trigger
handle.
Once installed, the handstrap provides a means for the user to secure the computer to their hand. It
is adjustable to fit practically any size hand and does not interfere with the multipurpose cable, if
connected, when the mobile device is in a cradle.
Figure 13 Attaching the Handstrap
1 Handstrap Retainer Bracket
2 Handstrap
3 Handstrap Clip
Tool Required: #1 Phillips Screwdriver (not supplied by LXE)
Installation
1. Place the MX7, with the screen facing down, on a flat stable surface.
2. Attach the handstrap retainer bracket to the MX7 with the screws provided.
3. Slip the Handstrap Clip into the bracket at the base of the MX7.
4. Making sure the closed loop fastener surfaces on the handstrap are facing up, slide the strap
through the pin in the retainer bracket and the clip.
5. Fold each end of the the strap over so that the closed loop fastener surfaces mate evenly.
6. Test the strap's connection making sure the MX7 is securely connected to each end of the
strap connectors.
Check the closed loop fastener, retainer bracket and clip connections frequently. If they have
loosened, they must be tightened before the MX7 is placed into service again.
