14 Inserting Fully Charged Battery
MX7 User’s Guide E-EQ-MX7OGWW-C
Inserting Fully Charged Battery
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS.
ATTENTION
II y a danger d’explosion s’il y a remplacement incorrect de la
batterie.
Remplacer uniquement avec une batterie du même type ou d’un
type equivalent recommandé par le constructeur. Mettre au
rebut les batteries usagées conformément aux instructions du
fabricant.
Note: The unit will not function unless the main battery pack is in place and securely latched.
Be sure to place the mobile device in Suspend before removing the battery. Failing to
properly place the device in Suspend mode will result in a loss of all unsaved data.
Figure 10 Main Battery Pack
The main battery is located in a compartment on the back of the unit. To insert or replace the
battery, complete the following steps:
1. Place the MX7 in Suspend mode.
2. Detach the bottom hook of the handstrap (if installed).
3. Press the battery locking tab up to release the main battery pack. The battery case serves as
the back cover for the battery well for the MX7.
4. Pull the battery up and out of the battery well with a hinge motion. Place the discharged
battery pack in a powered battery charger/analyzer.
5. Tilt the end (without the latch) of the fully charged battery pack into the upper end of the
battery compartment, and firmly press the other end (with the latch) until it is fully inserted
into the battery compartment.
6. Push down on the battery pack until it clicks into place.
7. Replace the handstrap clip in its holder.
Note: The battery should not be replaced in a dirty, harsh or hazardous environment. When the
battery is out of the MX7, any dust or moisture that enters the battery compartment can
get into the main unit, potentially causing damage.
