A SERVICE OF

logo

216
Chapter 7 The Super-Set Commands
Printer Protocol Select
ASCII Code SSCC P
n
Hex Code SSCC 50
n
Dec Code SSCC 80
n
Purpose Selects (changes) printer protocol.
Comment When the emulation receives this command, a software reset is
performed as if the emulation were powered-up in the
corresponding protocol.
NOTE: The printer protocol may also be selected from the control panel.
Software Page Eject
ASCII Code SSCC J
Hex Code SSCC 4A
Dec Code SSCC 74
Purpose Performs a “page eject” through software. This function is
identical to a page eject executed via the control panel (if
available on your printer).
Table 59. Printer Protocol Select
n
Value (hex) Protocol
n
= 00 or 30 P-Series
n
= 01 or 31 P-Series XQ*
n
= 02 or 32 Serial Matrix
n
= 03 or 33 Proprinter III XL
n
= 04 or 34 Epson FX
*If P-Series XQ is selected, then you cannot use this command to exit the
protocol.