Making a State Analyzer Measurement
This state analyzer program selects the HP 16554A/HP 16555A/HP 16555D
module, displays the configuration menu, defines a state machine, displays
the state trigger menu, sets a state trigger for multilevel triggering. This
program then starts a single acquisition measurement while checking for
measurement completion.
This program is written so that you can run it with the HP E2433-60004 Logic
Analyzer Training Board. This example is the same as the "Multilevel State
Triggering" example in chapter 9 of the HP E2433 Logic Analyzer Training
Kit.
10 ! ******************** STATE ANALYZER EXAMPLE *************************
20 ! for the HP 16554A/HP 16555A/HP 16555D Logic Analyzer
30 !
40 ! ************* SELECT THE HP 16554/HP 16555 MODULE *******************
50 ! Select slot in which the HP 16554A/HP 16555A/HP 16555D is installed.
60 ! In this example, it is in slot B of the mainframe.
70 !
80 OUTPUT 707;":SELECT 2"
90 !
100 ! ******************** CONFIGURE THE STATE ANALYZER **********************
110 ! Name Machine 1 "STATE," configure Machine 1 as a state analyzer, assign
120 ! pod 1 to Machine 1, and display System Configuration menu of the
130 ! HP 16554A/HP 16555A/HP 16555D.
140 !
150 OUTPUT 707;":MACHINE1:NAME ’STATE’"
160 OUTPUT 707;":MACHINE1:TYPE STATE"
170 OUTPUT 707;":MACHINE1:ASSIGN 1"
180 OUTPUT 707;":MENU 2,0"
190 !
200 ! ******************* SETUP THE FORMAT SPECIFICATION *********************
210 ! Make a label "SCOUNT," give the label a positive polarity, and
220 ! assign the lower 8 bits.
230 !
240 OUTPUT 707;":MACHINE1:SFORMAT:REMOVE ALL"
250 OUTPUT 707;":MACHINE1:SFORMAT:LABEL ’SCOUNT’, POS, 0,0,255"
260 !
Programming Examples
Making a State Analyzer Measurement
18–5
