Control panel message Description Recommended action
LOAD TRAY X:
<TYPE> <SIZE>
For help press
alternates with
LOAD TRAY X:
<TYPE> <SIZE>
Move tray switch to STANDARD
To use another
tray press
Tray X is either empty or configured for a
type and size other than specified in the
job.
1.
Press
for help.
2. Follow the instructions on the display
to load paper or configure the tray.
HP recommends moving the tray
switch to Standard.
3. Press
and to step through the
instructions.
4.
To exit help, press
.
or
Press
to print from another tray.
Loading
program x
Do not power off
Programs and fonts can be stored on the
printer file system and are loaded into
RAM when the printer is turned on. The
number X specifies a sequence number
indicating the current program being
loaded.
No action necessary.
If no paper is in the manual feed
tray:
MANUALLY FEED
<TYPE> <SIZE>
For help press
alternates with
MANUALLY FEED
<TYPE> <SIZE>
To continue press
Paper is in Tray 1, but a job sent requires
a specific paper type and size that is not
currently available.
Press to print from the tray.
Or follow the instructions below and load
the correct paper.
1.
Press
for help.
2. Follow the instructions on the display
to load the correct paper.
3. Press
and to step through the
instructions.
4.
To exit help, press
.
MANUALLY FEED
<TYPE> <SIZE>
For help press
alternates with
MANUALLY FEED
<TYPE> <SIZE>
To use another
tray press
There is no paper in the tray and a job
sent requires a specific paper type and
size that is not currently available through
Tray 1.
Press to print from another tray.
Or follow the instructions below to load
the correct paper.
1.
Press
for help.
2. Follow the instructions on the display
to load the correct paper.
3. Press
and to step through the
instructions.
4.
To exit help, press
.
Moving...
MP tray solenoid
To exit press
Cancel Job key
The printer is executing a Component
Test and the component selected is MP
Tray Feed Solenoid.
No action necessary.
ENWW Control panel messages 121
