Control panel message Description Recommended action
CPR SENSOR
OUT OF RANGE
A color plane registration (CPR) error
was detected during calibration.
1. Force a calibration by selecting
Calibrate Now from from the Print
Quality menu.
2. If the message persists, contact
HP Support.
DATA RECEIVED
To print last page
press
The printer received data and is waiting
for a form feed. When the printer
receives another file, the message
should disappear.
Press to continue.
Deleting...
<JOB NAME>
The printer is currently deleting the
stored job.
No action necessary.
DISK DEVICE
FAILURE
alternates with
Ready
For menus press
A device failure has occurred on the
specified drive.
1. Printing may continue for jobs that
do not require access to the disk
drive.
2. To clear the message, turn the
printer off and then back on.
3. If the message persists, remove and
re-install the EIO disk drive.
4. If the message persists, replace the
EIO disk drive.
DISK FILE
OPERATION FAILED
alternates with
Ready
For menus press
The printer received a PJL file system
command that attempted to perform an
illogical operation (for example, to
download a file to a non-existent
directory).
1. Printing may continue.
2. Turn the printer off and then back
on.
3. If the message reappears, there may
be a problem with the software
application.
DISK FILE
SYSTEM IS FULL
alternates with
Ready
For menus press
The printer received a PJL file system
command that attempted to store
something on the file system but was
unsuccessful because the file system is
full.
1. Use the HP Web Jetadmin software
to delete files from the EIO disk drive
and try again.
2. To remove this message from the
display, turn the printer off and then
back on.
DISK IS
WRITE PROTECTED
alternates with
Ready
For menus press
The file system device is protected and
no new files can be written to it.
1. To enable writing to the disk, turn off
write protection, using HP Web
Jetadmin.
2. To remove this message from the
display, turn the printer off and then
back on.
Doors open.
Test aborted.
A printer door has been opened during a
test. The test has been aborted.
Close the door and restart the test.
EIO DISK X
initializing
The EIO disk device in slot X is
initializing.
No action necessary.
ENWW Control panel messages 117
