If a printer was selected during OS/2 installation:
1 Point to the printer object.
2 Click mouse button 2.
3 Select Settings.
4 Select the Printer driver tab.
5 Point to one of the printer driver objects.
6 Click mouse button 2.
7 Select Install.
8 Select Other OS/2 printer driver.
9 Insert the CD-ROM containing the printer drivers into the CD-ROM
drive.
10 Select Refresh. Wait until the window fills with printer drivers.
11 Select one or more drivers by clicking on the left mouse button over
the desired driver.
12 Select Install.
IBM LAN Server 3.x / 4.x
For IBM LAN Server 3.x networks, install the software on the server.
On IBM LAN Server 4.x networks, install the software on the client or
server. Proceed as follows:
1 Verify your system requirements. Refer to the appropriate chapter in
the HP JetDirect Software Installation Guide.
2 Shutdown active programs.
3 Insert the JetDirect CD-ROM into the CD-ROM drive.
4 Display the OS/2 command window using the following steps:
a Double-click the OS/2 System icon
b Double click the Command Prompts icon
c Double-click the OS/2 Window icon
5 At the OS/2 command prompt, go to the CD-ROM drive and the
OS2WARP directory on the CD-ROM. Then go to the subdirectory for
the language you want.
Note
The following instructions assume you chose the
\OS2WARP\ENGLISH subdirectory.
6 Use the JETINST command to start the installation:
JETINST <sourcedrive:> <bootdrive:> <option>
where, <sourcedrive:> points to a directory containing these
install files.
<bootdrive:> OS/2 boot partition where you want to
install this software
<option> CLIENT to install as a client
or,
HP to install as a print server (default)
EN Getting Started Guide - 35
