A SERVICE OF

logo

3-8 P/N 480-0005-00-15
Chapter 3: Installation
Connect to Ethernet LAN (with CPU Card)
You can use these instructions for general connection purposes only. The Ethernet hub/switch manufacturer
documentation should provide specific instructions for connection to another device, such as Tenor CMS. One
Ethernet port is enabled; the other three ports are not used.
NOTE: For illustrations purposes, the unit is shown with CMS240 (2 slot) with AC power.
Figure 3-5 Connect to Ethernet Hub/Switch
1. Plug one end of the grey RJ-45 ethernet cable into one of the ports on the CPU rear transition module
labeled 10/100 Ethernet.
2. Plug the other end of the cable into the Ethernet hub/switch port. If a custom cable or adapter is required,
see Chapter 2: Hardware Components for Ethernet RJ-45 10/100.
Data
Network
Ethernet Hub/Switch
Chassis Rear (AC view)
10/100
Ethernet
1
2
3
4
5
6
7
8
DS1
Link TX/RX
Link TX/RX
CPU
2
4
8
3
7
26
15
TX/RX
1
2
3
4
Link
Config
1
2
3
4
Off
On
Console
10/100
Ethernet
1
0
CPU
2
4
8
3
7
26
15
TX/RX
1
2
3
4
Link
Confi g
1
2
3
4
Off On
Consol e
10/10 0
Et h er net