To wire the stereo audio output connector:
Step 1: Strip and insert the speaker wires into the connector and tighten the
captive screws. Be sure to observe the correct polarity.
Do not tin the wires!
Step 2: Insert the wired connector into the amplifier output and secure the locking
screws on either side.
8Ω / 4Ω OUTPUTS
CLASS 2 WIRING
1
2
ç
Mono audio output connector — Marked “+” and “-”, wire the included 2-pole,
5 mm screw lock captive screw connector for mono audio. See the following steps on
the next page. Output is designed to power 70 V (XPA 2001-70V) or
100 V (XPA 2001-100V) line distribution systems and is rated at 200 watts.
NOTES: • You must use Class 2 wiring for this output to comply with UL
requirements.
• The mono audio output connector may be labeled one of two ways
(see the images below). The wiring and function are the same,
whichever way your product is labeled.
XPA 2001-70V
OUTPUT
70V
70 V OUTPUT
CLASS 2 WIRING
OUTPUT
100V
100 V OUTPUT
CLASS 2 WIRING
XPA 2001-100V
or or
ATTENTION: Failure to follow these instructions may result in damage to
the unit.
Do not tie channel outputs 1 and 2 to each other or to ground.
Doing so will short out the outputs and/or damage the amplifier.
XTRA Series • Operation 15
