A SERVICE OF

logo

Options
Problem
Solution
A pull tractor is
installed and the
printer
does
not feed
continuous paper
properly (continued).
Skip over perforation
is set, but the
perforation does not
fall
in the center
of
the skip.
The paper cutter is
installed
and the
printer does not feed
continuous paper
properly.
When you press the
TEAR OFF
or
FRONTREAR
button,
the paper cutter does
not cut the paper.
Your application program may cancel the
skip over perforation set by DIP switch
3-3.
Check that your application program’s
settings are correct.
The page length may be set incorrectly. Set
DIP
swi&ch
3-2 to match your paper length.
You
can
also
set the page length using
ESC
C
or
ESC
C
0.
See pages
3-17,
9-13,
and
9-14.
The top of form position may be too high
or too low. Adjust the top of form position
so that
the perforation is centered within
the skip area. See page
3-33.
The paper cutter’s connector may not be
plugged securely into the printer. Turn off
the printer. Open the rear flap and check
the paper cutter connector. See page
5-22.
7-20
Troubleshooting