A SERVICE OF

logo

Open as PDF
next previous
Paper Handling
Problem
Solution
The printer does not
feed continuous paper
properly (continued).
Skip over perforation is
set, but the
petftiration
does not fall in the
center
of
the skip.
The top of form
position shifts slightly
when you print
several pages.
Your application program may cancel the
5kip
over perforation set by DIP switch
3-3.
Check that your application program’s
settings are correct.
The page length may be set incorrectly. Set
DIP switch
3-2
to match your paper length.
If your application program allows you to
use control codes, you can set the page
length using
ESC
C
or
ESC
C
0.
See pages
3-17,
9-13
and
9-14
The top of form position may be too high
or too low. Adjust the top of form position
so that the perforation is centered within
the skip area. See page
3-33.
The paper may be too heavy for the built-in
tractor. When you require highly accurate
paper feeding such as when you print
carbon copies, use the optional pull tractor.
See page
5-2.
7-16
Troubleshooting