xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
743
config wac default_redirpath
authentication.
Parameters
string - The URL that the client will be redirected to after successful authentication. By
default, the redirected path is cleared
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To config WAC default redirect URL:
DGS-3627:admin# config wac default_redirpath http://www.dlink.com
Command: config wac default_redirpath http://www.dlink.com
Success.
config wac clear_default_redirpath
Purpose Used to clear WAC default redirect URL.
Syntax
config wac clear_default_redirpath
Description When the string is cleared, the client will not be redirected to another URL after successful
authentication.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To clear WAC default redirect URL:
DGS-3627:admin# config wac clear_default_redirpath
Success.
config wac virtual_ip
Purpose Used to config the virtual IP address for WAC.
Syntax
config wac virtual_ip { < ipaddr > | < ipv6addr > } (1)
Description The virtual IP of WAC is used to accept authentication request from unauthenticated host.
Only requests sent to this IP will get response correctly.
This IP does not respond to ARP request or ICMP packet!
Parameters
ipaddr - To specify the IP address of the virtual IP.
ipv6addr - To specify the IPv6 address of the virtual IP.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
Set IPv4 virtual IP address:
