xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
348
config route_map sequence set
or incomplete.
dampening - The dampening timer and parameter.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the route map match access list “ac_list1” and set the metric to 50:
DGS-3627:admin# config route_map map1 sequence 10 match add ip address ac_list1
Command:4# config route_map map1 sequence 10 match add ip address ac_list1
DGS-3627:admin# config route_map map1 sequence 10 set add metric 50
Command:4# config route_map map1 sequence 10 set add metric 50
Success.
debug routefilter show
Purpose This command is used to show route filter information in kernel, including prefix list, access
list, and route map.
Syntax
debug routefilter show [prefix_list | access_list | route_map]
Description This command is used to show route filter information in kernel, including prefix list, access
list, and route map.
Parameters
enable - Enable the routefilter debug function
disable - Disable the routefilter debug function
Restrictions Only Administrator level users can issue this command.
Example usage:
To show route filter information in kernel.
DGS-3627:admin# debug routefilter show route_map
Command:4# debug routefilter show route_map
route-map map1,r_id:1,permit
Sequence 10
Match clauses:
ip address (access-lists): ac_list1
Set clauses:
metric 50
Sequence 20
Match clauses:
Set clauses:
