Filter
Top Products
930756 Rev. A
G. ARMRESTS ADJUSTMENT
1. Width Adjustment (Figure 12)
a.
Insert armrest support inside of 1" square tube (B) located on back of the seat.
b. Repeat for other side of seat.
c. Position armrest at appropriate width.
d
. Tighten knob screws (C) on square tube.
2. Angle Adjustment (Figure 13)
a. Flip back armrest.
b. Adjust the angle of the armrest by turning the bolt (D) clockwise to reduce the angle
and counter clockwise to increase the angle.
c. Fully tighten the jam nut after turning the bolt.
3. Height Adjustment (Figure 14)
a. Loosen thumb screw behind the arm pad (E).
b. Adjust the height to the desired setting.
c. Replace thumb screw and tighten.
Avoid pinching fingers in the flip-back armrest.
H. BACKREST
Adjustment for the High Back Contour Seat
(Figure 15)
a. Pull lever (H) upwards.
b. Lean back to desired position.
c. Release lever (H).
CAUTION– Backrest latches must be locked into place before operating wheelchair.
I. SEAT HEIGHT ADJUSTMENT
(Figure 16)
1. Remove pins from all four seat mount posts.
2. Select the desired seat height (rear seat mount should never be more than one posi-
tion lower then the front).
3. Reinsert the pins.
Ensure both front seat posts are positioned to the same height. Rear seat posts
should also be set to the same height.
IX. Set-Up, Adjustment & Use
23
English
D
12
13
H
E
14
15
16
B
C