Filter
Top Products
Page 50 of 77 SCW Series Central Chilling Stations
8-3 Getting Started on the SCW Series Advanced
Touchscreen Interface
Figure 8
Main Menu Screen
The Main Menu screen lets you gain access to:
• “Active Alarms” contains the current alarm(s) of the system
• “Al;arm History” contains the last thirty (30) alarms that
were activated.
• “Compressor Hourmeters” contains the lifetime and
resettable hour meters to show the number of hours that the
compressors have been running
• If the chiller was configured to operate the chilled water pump
tank, there are three screens to configure and view the pump
tank setup. The configuration screen allows for the user to turn
on or off any of the pumps as well as configuring the lead/lag
rotation (if multiple pumps were configured)
• “Chiller Configuration” shows the configuration of the
chiller itself including the chiller temperature setpoint,
temperature alarm settings, as well as setting up the lead/lag
rotation, and the ability to turn on and off the compressors.
• “PanelView Utilities” and “ACS Service” are both
password protected sections of the PLC that are used to
configure the display and the initial configuration of the chiller
and system.
The following sections in this chapter list the information you need
to navigate through these screens for operating and monitoring
your SCW Series central chilling station with the Standard Control
Package.
8-4 Viewing and Operating Chiller Compressors
Viewing Compressor Status
To view the status of the chiller compressors, start at the Main
Menu screen, then: