Filter
Top Products
English
1188
4 Troubleshooting
Display Remedy
Please check that you operated the
appliance correctly. If not, interrupt
the command chain by pressing the
CL key.
The scale sets the value zero auto-
matically when it is switched on. If
the scale is outside the set tolerance
band, the display indicates --0--.
Clip off the platform. Possibly remove
any soiling. If the scale fails to
display zero after a few seconds, ple-
ase inform your service partner
Underload: Only the lower horizontal
lines appear in the display pane.
Switch off the scale and switch it
back on again. The zero point is
reset automatically
Overload: Only the upper horizontal
lines appear in the display pane. The
maximum weighing range is excee-
ded.
Remove part of the weighing product
from the scale.
Part weight too small.
Zeroing limit overshot or undershot.
Not possible to tare an unloaded
scale; not possible in overload.
Not possible to print in underload or
overload.
Switchover kg/lb locked.
In case of other error messages,
please contact your service partner.
Ba_3010_GB.qxd 03.04.2008 17:08 Seite 18