Filter
Top Products
7
To turn the power on■
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-
by mode.
Display brightness control■
To dim the display brightness, press the DIMMER button
on the remote control.
Dimmer 1
Dimmer 2
Dimmer Off
(Display is dim).
(Display is bright).
(Display gets dimmer).
Volume auto fade-in■
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 12 and fades in to the
last set level.
Volume control■
Press VOLUME (+ or -) on the main unit or VOL +/- on the
remote control to increase or decrease the volume.
Direct key power on function■
When you press any of the following buttons, the unit
turns on.
iPod, CD/USB, AUDIO IN, TUNER on the remote
control: Selected function is activated.
/ button on the main unit: The unit turns on and
playback of the last function will start (CD, TUNER,
USB, iPod, AUDIO IN)
●
●
Auto power off function■
The main unit will enter the stand-by mode (when iPad,
iPod or iPhone is not connected) after 15 minutes of
inactivity during:
iPod: Not docked.
Audio In: No detection of input signal.
CD: In the stop mode or no disc.
USB: In the stop mode or no media.
Note:
However, if iPod or iPhone is docked, the unit will begin
charging.
“Charge Mode” will be displayed.
Muting■
The volume is muted temporarily when pressing the MUTE
button on the remote control. Press again to restore the
volume.
X-Bass control■
When the power is rst turned on, the unit will enter the
extra bass mode which emphasises the bass frequencies,
and “X-BASS” indicator will appear. To cancel the extra
bass mode, press the X-BASS button on the remote
control.
Bass control■
Press the BASS/TREBLE button to select “Bass”.
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the bass. “X-BASS” indicator will disappear.
- 5 ↔ - 4
........
↔ + 4 ↔ + 5
Treble control■
Press the BASS/TREBLE button to select “Treble”.
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the treble. “X-BASS” indicator will disappear.
- 5 ↔ - 4
........
↔ + 4 ↔ + 5
Function■
When the FUNCTION button on main unit is pressed, the
current function will change to different mode. Press the
FUNCTION button repeatedly to select desired function.
CD FM MONOFM STEREO
AM
Audio In
iPod USB
Note:
The backup function will protect the memorised function
mode for a few hours should there be a power failure or
the AC power lead becomes disconnected.
1�
2�
1�
2�
General control
DK-KP82PH_OM_EN_SCA.indd 7 2013-02-26 07:33:17