Sharp DK-KP82PH Microscope & Magnifier User Manual


 
6
Battery installation
Open the battery cover.
Insert the supplied battery according to the terminal
indicated in the battery compartment.
When inserting or removing the battery, push it towards
the (–) battery terminals.
Close the cover.
Caution:
Remove the battery if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
Do not use rechargeable battery (nickel-cadmium
battery, etc.).
Installing the battery incorrectly may cause the unit to
malfunction.
Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, re
or the like.
Notes concerning use:
Replace the battery if the operating distance is reduced
or if the operation becomes erratic. Purchase an “AA”
size battery (UM/SUM-3, R6, HP-7 or similar).
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
Keep the remote control away from moisture, heat,
shock, and vibrations.
1�
2�
3�
Test of the remote control
Check the remote control after checking all the connections.
Point the remote control directly at the remote sensor on
the unit. The remote control can be used within the range
shown below:
Remote sensor
0.2 m - 6 m
(8” - 20’ )
Remote control
DK-KP82PH_OM_EN_SCA.indd 6 2013-02-26 07:33:16