Filter
Top Products
5
Aerial connection■
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket
and position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Installing the AM loop aerial:
<Assembling> <Attaching to the wall>
Wall
Screws (not supplied)
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
AC power connection■
After checking all the connections have been made correctly,
plug the AC power lead of this unit into the wall socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
Demonstration mode■
The rst time the unit is plugged in, the unit will enter
the demonstration mode.
To cancel the demonstration mode, press the DEMO
button (remote control) during power stand-by mode.
The unit will enter the low power consumption mode.
To return to the demonstration mode, press the DEMO
button again.
If iPod or iPhone is docked, the unit will begin charging.
“Charge Mode” will be displayed. Demonstration
mode is invalid during charge mode.
●
●
●
●
Make sure to unplug the AC power lead before making any connections.
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
External FM aerial for better
reception (not supplied)
FM aerial
AM loop
aerial
System connections
DK-KP82PH_OM_EN_SCA.indd 5 2013-02-26 07:33:15