Filter
Top Products
11
Using the bodypack transmitter
Using the bodypack transmitter
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see the instruction manual of
the receiver).
2. Switch the bodypack transmitter on (see next section).
The transmission link is established and the receiver’s
RF level display “RF” reacts.
If you cannot establish a transmission link between
bodypack transmitter and receiver, refer to the chapter
“Synchronizing the bodypack transmitter with the receiver
– individual operation” on page 26.
Switching the bodypack transmitter on/off
̈ Push the two battery compartment catches ¸ and open
the battery compartment cover µ.
To switch the bodypack transmitter on (online operation):
It is vital to observe the notes on frequency
selection on page 26.
̈ Briefly press the ON/OFF button Ƹ.
The bodypack transmitter transmits an
RF signal.
The standard display “Frequency/Name”
appears on the display panel. The red ON LED ¿
lights up and the transmission icon ብ is
displayed.
You can switch the bodypack transmitter on and
deactivate the RF signal on switch-on. For more
information, see page 12.
Ƹ
¿
µ
¸
¸
ብ
ON/OFF