Filter
Top Products
25Using the VPAP Adapt SV
Servicing Menu
This menu displays the following information:
• SN—the flow generator’s serial number
• PCB—the flow generator’s PCB number (PCB—printed circuit board)
• SW—the version of software currently installed on the flow generator.
Treatment Screens
There are three Treatment screens displayed in the VPAP Adapt SV LCD. The
LCD will display the Treatment screens when treatment commences, and during
treatment if no key is pressed for 20 minutes.
Press the QuickView key at any point within a menu to display
Treatment Screen 1. You can return to your original screen if you press
the QuickView key again within 20 minutes.
Press the Right key to move from a Treatment screen to the Standby screen.
If an alarm is triggered while you are in the Treatment screens, the arrow will
flash. Press the Down key until you reach the alarm message.
Scroll through the screens in the usual way, using the Up/Down key.
Figure 16: Treatment Screen 1
Figure 17: Treatment Screen 2
Figure 18: Treatment Screen 3
Note: TARG is not a relevant parameter in CPAP mode.
ASV 5.0--15.0
exit
Treatment mode Pressure
LK:18L/min RR:12
VT: 428
Leak Respiratory rate
Tidal volume
MV:6.2 TARG:5.8
exit
Minute ventilation Target ventilation