Filter
Top Products
5Quick Setup Guide
Quick Setup Guide
1 Attach the air tubing and pressure sensor tube to the VPAP Adapt SV and mask
(page 9).
2
Attach a humidifier if required (page 11).
3
Switch on the VPAP Adapt SV. Make sure the mask is unblocked.
4
Select the mask setting (page 22).
5
Perform the Air Circuit Learn function (page 22) at first-time use, or if you are
adding or removing a component of the system (eg, a humidifier or anti-bacterial
filter).
6
Fit the mask and commence breathing into it. The SmartStart™ function should
trigger treatment to commence within the first couple of breaths. If not, press
the Start/Stop key once to commence treatment (page 17).
Note: You can observe treatment progress (eg, mask leak) via the Treatment
screens (page 25).
7
Remove your mask to stop treatment. If SmartStop is enabled, treatment will
stop automatically. If the SmartStop function has been disabled, press the
Start/Stop key once.