Filter
Top Products
14
5
Connect the mask system to the free end of the long air tubing. The final
assembly should look like this:
6
Switch on the HumidAire and the VPAP Adapt SV.
!
WARNING
Make sure that the power cords and plugs are in good condition and the
equipment is not damaged.
7
Perform the Air Circuit Learn function (see page 22).
For information about filling and maintaining your humidifier, refer to the
HumidAire User’s Manual.
The VPAP Adapt SV is now ready for use with the HumidAire. See “Starting
Treatment” on page 17.
!
CAUTIONS
• Set up the HumidAire and the VPAP Adapt SV unit so that the tubing to
the mask runs higher than the machines. This will prevent condensation
build-up.
• If condensation appears in the mask, turn the humidifier settings down.