Filter
Top Products
14 www.pridemobility.com Backpacker
IV. OPERATION
WARNING! Prevent product damage! Never attempt to secure the Y-strap over the seatback
or armrests of the mobility device.
5. Pull the end of the strap tightly to remove any excess slack over the seat.
NOTE: Inspect the Y-strap before each use to ensure there are no signs of fraying or wear. Ensure that
the mobility device is secured properly before transport. Pride is not liable for damage or loss resulting
from improper securing of a mobility device.
6. Press and hold the “UP” button. See figure 7. The lift will move up to its highest lift point, then slide into the van.
Once the mobility device is stowed completely within the van, release the button.
NOTE: Make sure that the van has enough headroom to accommodate the height of the mobility device
before loading it into the van. Lower the tiller, adjust the seatback angle, or remove the seat if necessary.
Refer to the mobility device owner’s manual for more information on these adjustments.
WARNING! Prevent vehicle damage! Do not exceed the load limits of your vehicle as
specified by the vehicle manufacturer.
WARNING! Do not sit on your mobility device while it is in a moving vehicle. Personal
injury and/or property damage may result.
When you are ready to remove the mobility device from the van, lower the platform to the ground, unfasten the
Y-strap, and drive the mobility device off of the platform. Once unloading is complete, return the lift platform
into the van.