Filter
Top Products
12 www.pridemobility.com Backpacker
III. INSTALLATION
Figure 6. Onboard Battery Installation
PROTRUDING BOLTS
6. Reinstall the 15-amp fuse to the wiring harness.
WARNING! Before operating the lift,
inspect the wiring harness for proper
routing and grounding. Improper
routing can cause damage to the
harness, and improper grounding can
cause damage to the electrical
system.
Onboard Battery Installation
The optional onboard battery is designed for easy installation
as it does not require any wires to be routed through or
under the vehicle.
Follow these steps to install the onboard battery:
1. Remove the rubber caps and nuts from the protrud-
ing bolts on the side of the lift motor housing. See
figure 6.
2. Mount the battery case onto the protruding bolts and
secure into position with the nuts removed earlier. See
figure 6.
3. Insert the onboard battery into the battery case, making
sure that the connector on the bottom of the battery
aligns and fully connects with the mating connector
inside the battery case.
4. Connect the male connector on the battery cable
to the female connector at the base of the Back-
packer.
5. Secure the battery cable to the other cables with
wire ties.