Filter
Top Products
43
Celebrity X www.pridemobility.com
Model Numbers 3-wheel: SC4001, 4-wheel: SC4401
Maximum Allowable Incline 6° (10.5%)
Maximum Obstacle Climbing Ability 2 in. (5 cm)
Overall Length
3
3-wheel: 46 in. (116.84 cm), 4-wheel: 46.75 in (118.75 cm)
Overall Width
3
24 in. (61 cm)
Total Weight Without Batteries
6
3-wheel: 144.5 lbs. (65.54 kg), 4-wheel: 154.5 lbs. (70.1 kg)
Heaviest Piece When Disassembled Front section:
3-wheel: 56 lbs. (25.40 kg), 4-wheel: 65.5 lbs. (29.71 kg)
Turning Radius
3
3-wheel: 41.5 in. (105.41 cm) 4-wheel: 54 in. (137.16 cm)
Speed (Maximum)
1
Up to 6 mph (9.66 km/h)
Range Per Charge
1,
2
With 40 Ah batteries
3-wheel: 16.6 miles (27 km)
4-wheel: 14 miles (22.5 km)
Ground Clearance 2.25 in. (5.7 cm)
Weight Capacity 350 lbs. (159 kg)
Standard Seating Type
Medium back deluxe foldable molded plastic
Weight: 51 lbs. (23 kg)
Material: Vinyl
Dimensions:18 in. (45.72 cm) width
18 in. (45.72 cm) depth
Drive System Rear-wheel drive, sealed transaxle, 24 volt DC motor
Tires
Solid
Front: 3.5 in. x 10 in. (8.89 cm x 25.40 cm)
Rear:4 in. x 10 in. (10.16 cm x 25.40 cm )
Battery Requirements
4,5
Two 12-volt, deep-cycle
Size: U-1 (40 Ah optional)
Weight: 24.50 lbs. (11 kg) each U-1; or 32.5 lbs. (14.75 kg) each 40 Ah
Battery Charger Off-board
APPENDIX I - SPECIFICATIONS
1
Varies with user weight, terrain type, battery amp-hour (Ah), battery charge, battery condition, and tire condi-
tion. This specification can be subject to a variance of (+ or -) 10%.
2
Tested in accordance with ASNI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from
theoretical calculation based on battery specifications and drive system performance. Test conducted at maximum
weight capacity.
3
Due to manufacturing tolerances and continual product improvement, this specification can be subject to a
variance of (+ or - ) 3 %.
4
AGM or Gel-Cell type required. See IV. “Batteries and Charging.”
5
Battery weight may vary based on battery manufacturer.
6
Includes standard seat.
NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO 7176
series EN12184 standards. All specifications subject to change without notice.