Filter
Top Products
39
Celebrity X www.pridemobility.com
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorized Pride Provider. The following areas require periodic inspection and/or care and maintenance.
TIRE PRESSURE
If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure indicated on each tire.
WARNING! It is important that the psi/bar/kPa air pressure indicated on each tire be
maintained in pneumatic tires at all times. Do not underinflate or overinflate your tires.
Low pressure may result in loss of control, and overinflated tires may burst. Failure to
maintain the psi/bar/kPa air pressure indicated on pneumatic tires at all times may result
in tire and/or wheel failure.
Regularly inspect your scooter’s tires for signs of wear.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat or tire
tread, as this may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter.
Avoid using products that may scratch the surface of your scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or scooter finishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit flat in the battery wells.
ABS PLASTIC SHROUDS
The front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are
coated with an advanced formula urethane paint.
A light application of car wax will help the shrouds retain their high gloss.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi-
cally for wear by your authorized Pride Provider.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
You do not need to lubricate these items, as they are all prelubricated and sealed.
IX. CARE AND MAINTENANCE