Filter
Top Products
24
www.pridemobility.com Revo
Follow these easy steps to charge your batteries safely:
1. Position your scooter close to a standard electrical outlet.
2. Remove the key from the key switch.
3. Make certain that the manual freewheel lever is in the drive
(pushed back) position.
4. Remove the charger power cord receptacle cover from the
charger power cord receptacle and plug the 3-pin charger power
cord into the receptacle. See figure 8.
5. Make sure the battery charger switch is in the “off” position.
See figure 8B.
6. Extend the charger power cord and plug it into the electrical
outlet.
7. Turn the charger on. See figure 8B. It is recommended that you
charge your batteries for 8 to 14 hours.
8. When the batteries are fully charged, turn the charger off and
unplug the charger power cord from the electrical outlet and
then from the charger power cord receptacle.
9. Replace the charger power cord receptacle cover.
NOTE: There is a charger inhibit function on your scooter.
The scooter will not run and the battery condition meter will
not operate if the charger power cord is not disconnected from
the battery pack.
CHARGING THE BATTERIES OFF OF THE SCOOTER
Removing the battery packs and charging them off the scooter is
convenient should you want to leave the scooter in your vehicle.
To charge the batteries off of the scooter:
1. Remove the battery packs from the scooter and place them on a
flat, dry surface in exactly the same positions as they are on the
scooter.
2. Follow steps 4-9 from above.
3. Reinstall the batteries onto the scooter See IX, “Disassembly
and Assembly” for information on how to remove and position
the battery packs.
Figure 8. Charger Power Cord
Receptacle
Figure 8A. Off-Board Charger
I
O
ON/OFF SWITCH
PLUGS INTO THE CHARGER
POWER CORD RECEPTACLE
PLUGS INTO
ELECTRICAL
OUTLET
OFF ON
Figure 8B. Charger On/Off Switch
VI. BATTERIES AND CHARGING