Filter
Top Products
22
www.pridemobility.com Revo
VI. BATTERIES AND CHARGING
Figure 7. Battery Condition Meter
Your scooter is equipped with two sealed, maintenance free batteries.
! Charge the batteries prior to using your scooter for the first time.
! Keep the batteries fully charged to keep your scooter running smoothly.
OFF-BOARD BATTERY CHARGER VOLTAGE SWITCH
The offboard charger supplied with your scooter is equipped with a 115/230 voltage switch. The voltage switch is
preset at “115V” and is intended to be used with a standard 110/115V electrical outlet. Ensure this is the case
before attempting to insert the charger plug into the electrical outlet. If the setting is incorrect, the charger will not
function properly. Slide the switch to the prescribed position. See figure 7A.
READING YOUR BATTERY VOLTAGE
The battery condition meter on the tiller console uses a
color code to indicate the approximate strength of your
batteries. From right to left, green indicates fully charged
batteries, yellow a draining charge, and red indicates
that an immediate recharge is necessary. See figure 7.
To check the battery strength during charging, you must
first unplug the charger power cord and power up your
scooter by inserting the key into the key switch and turn-
ing it to the on position.
NOTE: To ensure the highest accuracy, the bat-
tery condition meter should be checked while op-
erating your scooter at full speed on a level sur-
face.
Figure 7A. Voltage Switch
VOLTAGE SWITCH