Filter
Top Products
37
Quantum Jazzy 1400 Series Rev D May04 www.pridemobility.com
VII. OPERATION
Drive Program Select Key
The drive program select key enables you to select a drive program and an actuator mode. Your Dynamic DX controller was
preprogrammed at the factory for five drive programs 1(slowest) to 5(fastest). The drive mode is indicated by a number in
the center of the keypad.
NOTE: The drive mode settings are preset at the factory. If your authorized Pride provider changes these settings, please make
note of these changes.
To change the drive mode program:
1. Press the drive mode select key.
2. Move the joystick right to increase the drive mode program.
3. Move the joystick left to decrease the drive mode program.
4. Press the drive mode select key.
Drive Mode and Actuator Display (also Remote Status Display)
This is a seven-segment light that displays the drive program. It also displays a drive inhibit and actuator mode (if applicable),
when they occur.
Actuator Select Keys with Lights
The actuator select keys can control up to five actuators independently. These actuators may control power elevating seats,
power elevating leg rests, power reclining seats, or tilt-in-space seats. If your controller is programmed with drive inhibit during
actuator operation, the drive inhibit symbol will be displayed during actuator operation. You control the actuators through the
actuator select keys and the joystick.
To move an actuator:
1. Press an actuator select key.
2. Move the joystick beyond half its travel in either the forward or reverse direction to move the actuator. Forward moves the
actuator up. Reverse moves the actuator down.
3. Press the actuator select key again to turn off the actuator.
Remote Status Light
This light will flash if there is an internal Dynamic DX Remote fault, or if an OONAPU fault has occurred. See Out Of Neutral
At Power Up.
Horn Key
The horn key activates the horn.
Battery Saver Feature
When the battery capacity drops to below 21V (typically two lights), the controller will reduce power chair performance to
conserve battery power.
Sleep Mode (If Enabled)
The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically shut off the main
power if the joystick is not moved in any direction for a period of time. This time factor is programmed into the controller. To
restore power and continue, push and key on the keypad.