Filter
Top Products
26 www.pridemobility.com Jazzy Select 14 Series
WARNING! Consult your authorized Pride Provider before attempting to change the anti-tip
height! Changing the anti-tip wheel height affects handling under deceleration!
WARNING! The higher you raise the anti-tip wheels, the more tendency your power chair has to
tilt forward when coming to a stop. You can compensate for this by making a small adjustment
to the pre-programmed deceleration setting in the controller or by moving the seat assembly
farther to the rear of your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
Anti-Tip Wheel Adjustment
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip
wheels are preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces,
it may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment
if either of the following occurs:
When coming to a stop, your power chair tips forward excessively.
The anti-tip wheels constantly rub the ground.
NOTE
:
Each pneumatic drive tire must be inflated to the
psi/bar/kPa air pressure rating indicated on the tire in
order for the anti-tip wheels to be properly adjusted.
To adjust the anti-tips:
1. Turn off the power to the controller.
2. Ensure the power chair is in drive mode.
3. Disconnect the controller connector from the power
base.
4. Remove the seat.
5. Remove the body shroud by lifting it straight up. See
figure 22.
6. Adjust the anti-tip adjustment nut so that the anti-tip
wheel is 0.50-1 in. (1.27-2.54 cm) off of the ground.
See figure 18.
7. Reinstall the body shroud.
8. Reinstall the seat.
9. Connect the controller connector to the power base.
ANTI-TIP
WHEEL
ANTI-TIP ADJUSTMENT
NUT
Figure 18. Anti-tip Adjustment
V. COMFORT ADJUSTMENTS