Filter
Top Products
24 www.pridemobility.com Jazzy Select 14 Series
V. COMFORT ADJUSTMENTS
SETSCREW
Figure 14. Underside of Armrest
Figure 15. Foot Platform Adjustment
FOOT PLATFORM BRACKET
ADJUSTMENT
SCREW
CONTROLLER
BRACKET
Controller Position
You can move the controller in toward or out away from
the armrest, or change the position of the controller for
either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 14.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the power
base.
3. Remove any wire ties securing the controller harness
to the armrest.
4. Flip up the armrest so it is perpendicular to the floor.
5. Loosen the setscrew on the controller bracket.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew in both armrests.
10. Route the controller harness to the back of the power
base and plug in the controller.
11. Secure the controller harness to the armrest with wire
ties. See figure 11.
NOTE: If your power chair is equipped with a Specialty
Seat or Synergy Seat, refer to the controller adjustment
information contained in separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several
heights.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform bracket
as shown in figure 15.
2. Reposition the foot platform to the desired height.
3. Reinstall the hardware.