Filter
Top Products
22 www.pridemobility.com Jazzy Select 14 Series
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to
increase your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller
position.
NOTE: If your power chair is equipped with a Specialty Seat or Synergy Seat, refer to the information provided
in separate manuals. If your power chair is equipped with a high-back seat or a reclining seat, refer to the
following information.
WARNING! The center of gravity of your power chair was factory set to a position that meets the
needs of the demographic majority of users. Your authorized Pride Provider has evaluated your
power chair and made any necessary adjustments to suit your specific requirements. Do not
change your seating configuration without first contacting Pride Mobility Products or your
authorized Pride Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to “Appendix I - Specifications” for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
V. COMFORT ADJUSTMENTS
Figure 12. Seat Height Adjustment
You may need the following to make comfort adjust-
ments:
metric/standard socket set and ratchet
adjustable wrench
thread lock
Seat Height Adjustment
You can change the seat height to one of two positions by
raising or lowering the seat tower.
To change the seat height:
1. Turn off the power to the controller.
2. Ensure the power chair is in drive mode.
3. Disconnect the controller connector from the power
base. See figure 6.
4. Disengage the seat release lever. See figure 5.
5. While holding the lever, swivel the seat left or right
and then pull it up and off of the power base.
6. Loosen the hardware at the rear of the seat tower.
7. Remove the seat height adjustment bolt, washers,
and nut from the seat tower. See figure 12.
8. Raise or lower the seat tower to the desired position.
9. Reinstall the seat height adjustment hardware to the
seat tower.
10. Tighten the hardware at the rear of the seat tower.
11. Reinstall the seat.
12. Reconnect the controller to the power base.
SEAT HEIGHT
ADJUSTMENT
BOLT
HARDWARE
SEAT TOWER