Pride Mobility Jazzy 1650 3EHD Mobility Aid User Manual


 
Quantum Jazzy 1650 Series www.pridemobility.com 27
LEG REST EXTENSION
LEG REST HANGER
ADJUSTMENT BOLT
ADJUSTMENT SCREWS
V. COMFORT ADJUSTMENTS
Heavy Duty Drop-in Leg Rests
You can adjust the forward/back position, as well as
the length of the heavy duty drop-in leg rests.
To adjust the forward/back position:
1. Remove the adjustment bolt from the side rail. See
figure 16.
2. Move the leg rest hanger in or out to the desired
position.
3. Align the adjustment holes in the leg rest hanger
with those in the side rail.
4. Reinstall the adjustment bolt to secure the leg rest
hanger.
To adjust the leg rest length:
1. Remove the adjustment screws from the leg rest
extension. See figure 16.
2. Slide the leg rest up or down to the desired length.
3. Align the adjustment holes in the leg rest extension
and reinstall the adjustment screws.
Figure 16. Heavy Duty Drop-In Leg Rests
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip
wheels are preset at the factory for smooth surfaces or indoor use only. If you plan on using your power chair on
rough surfaces, it may be necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may
need adjustment if the following occurs:
When coming to a stop, your power chair tips forward excessively.
The anti-tip wheels constantly rub the ground.
WARNING! Consult your Quantum Rehab Provider before attempting to change the anti-tip wheel
height! Changing the anti-tip wheel height affects handling under acceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s
tendency to tilt forward while decelerating. You can compensate for this by having your
Quantum Rehab Provider make a small adjustment to the pre-programmed deceleration setting
in the controller or by moving the seat assembly farther to the back of your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
NOTE: Each drive tire must be inflated to the psi/bar/kPa air pressure rating indicated on the tire for pneu-
matic tires. The user must also be seated in the power chair in order to properly adjust the anti-tip wheels.