Filter
Top Products
28 www.pridemobility.com Jazzy Select Series
NOTE: The most common configuration of the seat
adjustment hardware is shown in figure 19. Your
product may be equipped with a different
configuration. All configurations operate in a similar
manner.
Manual Recline Seatback Adjustment
If your power chair is equipped with a manual recline
seatback, you can adjust the seatback angle with the
seatback release lever. The lever is located on the right
side of the seat base. See figure 19.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with a limited-recline
seatback, you can adjust it to four (4) different angles:
90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge
and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of
the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the adjustment hardware on each side of the
armrest receiver bracket. See figure 19.
2. Loosen the adjustment hardware.
3. Slide the armrests in or out to the desired width.
4. Tighten the adjustment hardware.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicu-
lar to the floor. See figure 19.
2. Loosen the jam nut.
3. Turn the adjusting screw to raise or lower the front
of the armrest.
4. Tighten the jam nut to lock the adjusting screw into
place.
V. COMFORT ADJUSTMENTS
Figure 19. Armrest and Seatback Adjustments
SEATBACK
RELEASE
LEVER
ARMREST WIDTH
ADJUSTMENT
HARDWARE
JAM NUT
ARMREST
HEIGHT
ADJUSTING
SETSCREWS
ARMREST
ANGLE
ADJUSTMENT
SCREW