Filter
Top Products
Jazzy Select Series www.pridemobility.com 27
JOYSTICK
ACTUATOR LIGHT
ACTUATOR KEY
ON/OFF KEY
ACTUATOR LIGHT
ACTUATOR KEY
V. COMFORT ADJUSTMENTS
Seat Height Adjustment (Select 6 with Power Seat Only)
Your power chair is equipped with a power elevating seat. You can change the seat height through the controller.
To change the seat height:
1. Push the on/off key to power on the chair and the controller. See figure 18.
2. Push the desired actuator key to select actuator mode. See figure 18.
3. Push the joystick forward to raise the seat to the desired position.
4. Pull the joystick backward to lower the seat to the desired position.
5. Push the on/off key to return to drive mode. See figure 18.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit.
NOTE: For more information on operating the power elevating seat, contact your authorized Pride Provider.
WARNING! The power elevating seat option is intended for use on a level surface only. Never
raise the seat from its lowest position on an inclined surface. Failure to heed this warning can
result in the power chair tipping over.
WARNING! Never raise the seat from its lowest position when operating your power chair on
bumpy or uneven surfaces. Failure to heed this warning can result in the power chair tipping
over.
WARNING! Never raise the power elevating seat while your power chair is in the freewheel
mode.
WARNING! Always fasten the positioning belt when operating the power elevating seat.
WARNING! Pinch Point Hazard! Keep area around actuator clear when lowering power seat.
NOTE: The power elevating seat option is equipped with a system that reduces the speed of the power chair by
two-thirds when the seat is elevated more than approximately 0.75 in. (19 mm). Always check to be sure this
system is operating properly before using your power chair.
Figure 18. VR2 6-key Controller and Keypad