Filter
Top Products
Jazzy Select Series www.pridemobility.com 23
IV. ASSEMBLY
INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage
to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local
hardware stores or through your authorized Pride Provider.
Figure 13. Seat and Controller Assembly
Seat Installation (Select and Select 6 only)
It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
WARNING! Do not pick up the seat
frame by the armrests. They are free
to pivot, and you may lose control of
the seat if they do so.
To install the seat:
1. Slide the seat down onto the power base. See fig-
ure 13.
2. Install the controller into one of the armrests.
Tighten the setscrew with the supplied hex key.
See figure 13.
3. Lift the armrest straight up, then route the con-
troller harness and secure with wire ties as shown
in figure 13.
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller harness
with wire ties.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the
inside of the armrest pad. Use
correct tie-down points for the
controller harness to prevent the
harness from getting caught in the
drive tires, pinched in the seat
frame, or damaged when passing
through doorways.
4. Plug the controller harness into the connector on
the power base. See figure 6 or 7.
SEAT
CONTROLLER
POWER BASE
SETSCREW
WIRE
TIES