Filter
Top Products
24 www.pridemobility.com Jazzy Select Series
Seat Installation (Select 6 with Power Seat
only)
It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
Most seats are attached to the power base with the Uni-
versal Mounting System (UMS). The UMS consists of
universal parts that may be attached to any medium-
back or high-back seat, regardless of seat width or seat
depth. The two main components are aluminum extru-
sions mounted to the seat base. These extrusions attach
to a pair of trapeze bars that are mounted to the power
base. See figure 14.
WARNING! Do not pick up the seat
frame by the armrests. They are free
to pivot, and you may lose control of
the seat if they do so.
To install the power seat:
1. Tilt the seat back and slide the rear extrusion onto
the power seat base.
2. Lower the front extrusion onto the power seat base
until the seat locks into place.
3. Flip down the seat latch safety. See figure 15.
4. Connect the power seat connector to the power
base. See figure 14.
5. Lift the armrest straight up, then route the control-
ler harness and secure with wire ties as shown in
figure 16.
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller harness
with wire ties.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for the controller harness
to prevent the harness from getting
caught in the drive tires, pinched in
the seat frame, or damaged when
passing through doorways.
6. Plug the controller harness into the connector on
the power base. See figure 8.
NOTE: Refer to V. “Comfort Adjustments” for more
information on controller installation and adjust-
ment.
IV. ASSEMBLY
Figure 14. Universal Mounting System on Select 6 with Power
Seat
REAR EXTRUSION
FRONT EXTRUSION
SEAT LATCH
SAFETY
POWER SEAT
CONNECTOR